How do I fix code 33 on a Bryant furnace?

Check for air flow issues

1. Check condition of filter.
2. Open all vents and return registers.
3. Make sure the ducts and register grilles are clean.
4. Clean the A/C evaporator coil.
5. Check condition of the blower wheel.
6. Check blower motor and capacitor to make sure the blower motor is running up to speed.

How do you reset the code on a Bryant furnace?

To reset: Put setup switch “SW-1” in the “ON” position nad jumper thermostat terminals “R”, “W/W1” and “Y/Y2” simultaneously with the door switch pushed in and power to the unit “ON”. Disconnect jumper and place setup switch in the “OFF” position. If LED2 reappears, replace main control board. CODE: YELLOW LED3 ON.

What are the symptoms of a bad furnace ignitor?

4 Signs of a Faulty Furnace Ignitor

• The Furnace Stops Running. When a furnace won’t run at all, check for a bad ignitor.
• Your Furnace Blows Chilly Air. Unless you’ve set your thermostat to COOL, your furnace should not blow cold air.
• Does Your Furnace Short Cycle?
• A No Glow Ignitor.
• We Can Replace Your Furnace Ignitor.

How do you reset a furnace blower motor?

How to Find and Reset your Furnace Motor Blower

1. Step 1: Turn off the power to the furnace.
2. Step 2: Remove the blower compartment cover.
3. Step 3: Make sure the blower is completely cooled off.
4. Step 4: Locate the reset button.
5. Step 5: Press the button in (assuming that this is your issue and that the button has popped).

How do you know if furnace ignitor is bad?

Your furnace won’t run: The most obvious sign that your ignitor is bad is that it won’t ignite, and this generally manifests itself in your furnace failing to run when you activate it.

What does error code 41 mean on Bryant furnace?

Bryant error code 41 When the blower doesn’t run at the correct revolutions per minute, the error code 41 will flash. Bryant code 43 Should your furnace have developed a problem with the pressure switch calibration, the error code, 43 will inform you.

What is code 34 on a Bryant 90T furnace?

I have a code 34 with my 90t furnace. It has a clean flame I have a code 34 with my Bryant 90t furnace. It has a clean flame sensor and a new hot surface igniter – resistance is about 57 ohms. I’m not … read more

What does error code 13 mean on a Bryant furnace?

When your furnace displays error code 13, the limit switch is tripping due to various problems. Typically, your Bryant furnace will auto-reset after 3 hours. Error code 14 signals problems with ignition. It will take three hours until the control will reset automatically. Again, some ignition issues are causing improper functioning.

What is the error code on my Bryant 350mav036000?

i have a Bryant model 350MAV036000. It returns an error code 14 which refers to error code 34. I tried disconnecting the power to reset the furnace two different times with no lick.