Why wont my Wii U remote connect?

Possible solutions. Ensure that the Sensor Bar is plugged into the Wii U console and connected properly. If it is plugged in, unplug it and plug it back in a few times, checking after each attempt to see if the cursor shows up. You should feel it click into place when it is fully inserted.

How do I know if my Wii Remote is working?

Wii Remote Not Working Correctly (No Lights Appear at All)

1. Replace the batteries in the Wii Remote with a fresh set.
2. Once the batteries have been replaced, press any button on the Wii Remote to see if any lights appear.
3. Verify that your Wii Remote is functioning properly.

Where is the sync button on the Wii?

Open the SD Card Slot cover on the front of the Wii console. If you are using a Wii mini, the sync button is located on the left hand side next to the battery compartment. The sync button is a darker shade of red than the console.

How do you connect a Wii controller to a PC?

Plug the USB data cable into the USB port on the bottom of the Wii controller. Connect the opposite end of the cable into the USB port on the adapter. The computer will momentarily state that it has detected the new controller.

How do you sync a Wii controller?

Press the “Sync” button on the Wii console. Press the “Sync” button on the Wii Remote. The light on the controller will blink for several seconds. Once it stops blinking, your controller is synced to the console. Replace the Wii Remote’s battery cover and close the door on the front of the Nintendo Wii console.

How do you set up a Wii controller?

Press and release the SYNC button just below the batteries on the Wii Remote; the Player LED on the front of the Wii Remote will blink. While the lights are still blinking, quickly press and release the red SYNC button on the Wii console. When the Player LED blinking stops and stays lit, the syncing is complete.