How do you remove a transmission from a Chevy S10?

How to Drop a Transmission Out of an S10

1. Disconnect the battery from the truck, then jack up the truck and support it on jack stands.
2. Remove the gear shift lever of manual transmission trucks by first removing the gear shift knob, then sliding the shifter boot off the shifter.

What transmission is in my 1989 S10?

It was equipped with a 4L60 automatic transmission and a limited-slip differential with 3.42:1 gearing.

What transmission does a S10 have?

4L60-E Automatic The L60-E four-speed electronically-controlled automatic dates to1982 and transmitted power from the engine not only for the S10, but also for the sixth generation Corvettes. It served trucks up to 8,600 lbs.

What transmission is in a 1998 Chevy s10?

4-speed automatic
5-speed manual
1998 Chevrolet S-10/Transmission

What transmission is in 1998 S10?

Will a 2.8 transmission fit a 350?

No. the 2.8 700r4 is a 60 degree transmission, you need a 90 degree which is what bolts onto the 4.3 and 350 engines……

How much is a 700R4 transmission?

700R4 Transmission – $1,595| 5-Year Warranty.

Will a 4L60E bolt up to a 350?

The 4L60E will bolt straight up to your 350. :yes: You will need some way to control the tranny though. The OD is electronically controlled, hence the “E” at the end of the 4L60.

How do you remove the transmission from a Chevrolet S10 truck?

Removing the transmission from a Chevrolet S10 truck for replacement or repair requires the use of a transmission jack or cradle, which can be obtained from auto parts stores. Whether manual or automatic, removal of the transmission follows largely the same procedure.

How do I replace the catalytic converter on a Chevy S10?

On the S10, there is a hanger which holds the catalytic converter in place on the transmission. Remove this hanger. Unbolt the transmission supports from the underside of the truck, then slightly raise up on the transmission with the transmission jack.

How do you remove a transmission from a car?

Whether manual or automatic, removal of the transmission follows largely the same procedure. It involves removal of several parts to obtain clearance, then simply unbolting the transmission from the engine and lowering it to the ground.

How do you remove a shifter cable from a column-shift transmission?

Trucks with automatic column-shift transmissions require removal of the shifter cable from the transmission housing underneath the truck. This is accomplished by unbolting it from the transmission housing. Support the transmission with the transmission jack, then unbolt the transmission from the engine of the truck.