What is the TL071 JFET input single operational amplifier?

The TL071 is a high-speed JFET input single operational amplifier. This JFET input operational amplifier incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficient.

What is microphone preamplifier circuit?

Microphone Preamplifier Circuit is a low-cost high-performance amplifier with a lot of built-in features. It has short circuit protection along with low noise and low harmonic distortion. Using this IC rather than a transistor for amplification in the mic preamp state will give a much better distortion filter.

What ICs are used in the TL071 series?

Resistors and capacitors along with an electret mic are used at the input pins Pin2 and Pin3 of the IC. Voltage is applied at Pin 4 and 7. Another capacitor is at the output of the IC (pin 6) to cancel any noise. If you want to use other ICs in the TL071 series you can but the circuit performance might change a little.

What op-amp should I use for a mic preamp?

It has short circuit protection along with low noise and low harmonic distortion. Using this IC rather than a transistor for amplification in the mic preamp state will give a much better distortion filter. All low noise op-amp will be sufficient for this circuit such as TL082, NE55534, etc.

What makes the tl07x series unique?

The low harmonic distortion and low noise make the TL07x series ideally suited for high-fidelity and audio preamplifier applications. Each amplifier features JFET inputs (for high input impedance) coupled with bipolar output stages integrated on a single monolithic chip.

What is the difference between the JFET tl07x and tl08x series?

The JFET-input operational amplifiers in the TL07x series are similar to the TL08x series, with low input bias and offset currents and fast slew rate. The low harmonic distortion and low noise make the TL07x series ideally suited for high-fidelity and audio preamplifier applications.