What pressure should my ferroli boiler be?

What pressure should my ferroli boiler be?

between 1.0 and 2.0
Your boiler gauge should show that the boiler pressure is between 1.0 and 2.0. If the pressure drops below 1.0, then you’ll need to repressurise it.

Why does my ferroli boiler keep losing pressure?

Some Ferroli boilers will lockout if the pressure gets too low. Leaks are the most common cause of any boiler losing pressure. Most of the time the leak will occur on radiator valves, or valves on towel rails. However, the leak can sometimes come from the auto air vent in the boiler, or expansion vessel.

How do I reset my Ferroli Optimax HE 31c?

Press heating + and p02 appears. Press hot water + and 0 codes appear. Then press up or down on heating + or – to get o1 . Then press reset for ten seconds.

What should boiler pressure be?

Normal boiler pressure should be between about 1-2 bars. The ideal boiler pressure is often marked as a range in green on the gauge itself.

What does F1 mean on a Ferroli boiler?

When the unit is low on water pressure, the Ideal boiler F1 error code is displayed.

What happens if the pressure in boiler is too low?

If the pressure on your boiler is too low, then your central heating may not work, and if it’s too high, then it will be under too much strain and could also be prevented from working.

Is 2 bar too high for a boiler?

What Boiler Pressure Is “Too High”? Anything above a boiler pressure of 1.5 bar isn’t ideal. 2 bar starts to become more serious and when most boilers hit 3 bar, they’re in the red zone on the pressure gauge. So, the unit is likely to lock out and display a fault code.

Is 2.5 bar too high?

In this instance, a reading between 1.5 – 2.5 bar can be considered normal. A consistent 3 – 4 bar, however, is something to raise with a local heating engineer.

Why choose the Ferroli Optimax he 31 C?

Dear Customer, Thank you for choosing the OPTIMAX HE 31 C , a FERROLI wall-mounted boiler of the latest generation, featuring advanced design and cutting-edge technology. OPTIMAX HE 31 C is a high-efficiency condensing pre-mix appliance for heating and hot water pro- duction with extremely low emissions, running on natural gas or LPG.

What is an Optimax he 31 C?

OPTIMAX HE 31 C is a high-efficiency condensing pre-mix appliance for heating and hot water pro- duction with extremely low emissions, running on natural gas or LPG. The boiler consists of an aluminium laminar heat exchanger providing effective condensation of the water vapour contained in the flue gases, permitting extremely high efficiency.

How do I Commission my Optimax he 31 C boiler?

OPTIMAX HE 31 C 3.2 System start-up Commissioning must be performed by Qualified Personnel. Checks to be made at first ignition, and after all maintenance operations that involved discon- necting from the systems or an intervention of a safety device. Before lighting the boiler: • Open any isolation valves between the boiler and the system.

What to do if your Ferroli has low system pressure?

Low system pressureFill the ‘system to 1-1.5 bar. Before calling a Ferroli service engineer, check that the problem is not due to there being no gas or electricity, or low system pressure. 12 OPTIMAX HE 31 C 2.